Rubber gasket Daily life rubber products Rubber sealed loop Stabilizer for industrial use
Reason:
1. The incision position of the product cannot be opened
2. There will be leakage after being placed for a period of time after assembly
3. The usage flow rate is too large or too small
Possible Causes:
The surface treatment of the silicone gasket is not suitable.
The surface treatment of the vibrating plate is not conducive to the running of the silicone gasket.
Possible Causes:
1. The characteristics of the silicone material itself (self-healing).
2. The storage condition of the silicone gasket is not suitable.
Possible Causes:
1. The selected material is not suitable.
2. The silicone gasket is contaminated (raw material, process, storage).
Possible Causes:
1. When sealing and pressing, the metal or aluminum platinum is pressed against the silicone gasket, which makes the slit unable to close.
Possible causes:
1. The product surface grinding roughness is not enough
2. The product is made of low hardness material
3. The outer diameter of the product itself is large and the wire diameter is thin
Possible causes:
1. The size design of the sealing ring is unscientific
2. The size of the assembly is out of tolerance
3. Raw materials have poor resilience
Possible causes:
1. Low temperature resistant materials were not correctly selected during project development
2. The use temperature was not specified during project development
Possible causes due to seals:
1. There are fluff, foreign matter, and waste on the surface of the sealing ring.
2. The burr (flap) of the sealing ring is too large, and the surface of the product is defective.
3. The surface texture of the sealing ring is too rough or has transverse (radial) texture.
Miss Bai
Miss Ji
Mr. Wei
Miss Zhou
Miss Wang